Home / Collections / TPE-900 Series 3D Multi-Touch Evaluation Sensors / 3D Multi-Touch Force Sensor Controller

3D Multi-Touch Force Sensor Controller

$120.00
3D Multi-Touch Force Sensor Controller

3D Multi-Touch Force Sensor Controller

$120.00

has been successfully added to your cart . Feel free to continue shopping or check out .

description

Built to be used with our TPE-900 3D Multi-Touch evaluation sensors, the 'Snowboard' Controller has everything needed to demonstrate and evaluate the power of Tangio's 3D Touch.   

Features

General
- Arduino Leonardo compatible. 
- Microprocessor: Atmel ATMega32U4
- Operating voltage: 5V
- 20 digital I/O pins
- 7 PWM channels
- 12 analog input channels
- 32KB of flash memory of which 4KB used by boot loader
- 2.5KB of SRAM and 1KB of EEPROM
- 16MHz clock speed
- Communication - Micro B USB cable (included)
- Size: 94.1mm x 75.05mm

Extended Features
- Embedded force pressure distribution sensing IC - mutual resistive sensing with 10x7 and 16x10 channels and 256 pressure sensing levels (sensor is not included)
- 50Hz (20ms) frame rate for force sensing
- Embedded analog capacitive touch sensing IC - self capacitance sensing with 12 channels
- Onboard I2C interface port for easy connection with external sensors

Arduino Pin Assignments
Six pins of Arduino Leonardo in SNOWBOARD are assigned to extended features of SNOWBOARD. In a case you want to disable part or all of SNOWBOARD features, the assigned pins are easily released by using onboard hardware switch.
- D2 and D3 are assigned to SDA and SCL, respectively, which exactly follows Arduino convention.
- D4 is assigned to reset pin for an external sensor (RESET)
- D5 is assigned to interrupt request for an external sensor (IRQ_E)
- D6 is assigned to interrupt request for onboard capacitive touch sensing IC (IRQ_T)
- D7 is assigned to interrupt request for onboard force sensing IC (IRQ_F)

Documents
Snowboard documents
Snowboard library and examples